GE 90-30 PLC Series Installation And Hardware Manual page 425

J
IC649AEA103 Ethernet 10BASE2 Transceiver
Note:
•
•
•
•
•
(23 mm)
2 inches
(51 mm)
Figure J-2. IC649AEA103 Ethernet 10BASE2 Transceiver
Power Requirement
This unit draws 400 mA @ 5Vdc from the Ethernet Interface via the AAUI connector.
LED Indicator Light
Located on the side of the unit as shown in the figure. This green LED turns on to indicate the
presence of 5Vdc power to the unit.
J-2 Series 90-30 PLC Installation and Hardware Manual – August 2002
This transceiver replaces obsolete catalog number IC649AEA101
Compliant with the IEEE 802.3 Ethernet specification for 10BASE2.
A standard BNC connector is mounted on the body of the transceiver for connection to thin
coaxial Ethernet cable.
This unit has an attached 10" (254 mm) cable with standard 14-pin AAUI connector for
connecting to a Series 90-30 Ethernet module (IC693CMM321) or CPU with Ethernet
interface (IC693CPU364).
SQE slide switch is set to enabled position at the factory. It must be in this position for proper
operation with GE Ethernet products IC693CMM321 and IC693CPU364 (see figure
below).
Power LED indicator light.
3.2 inches (81 mm)
0.9"
BNC Connector
10 inches (254mm)
Slide Switch in this Direction to Enable SQE.
SQE Slide Switch (recessed in housing)
Green LED
Power Indicator
14-Pin AAUI
Connector
7 6 5 4 3 2 1
8 9 10 11 12 13 14
GFK-0356Q