Installing A Module's Terminal Board - GE 90-30 PLC Series Installation And Hardware Manual

Installing a Module's Terminal Board

Note: Modules IC693MDL730F (and later) and IC693MDL731F (and later) have special terminal
boards that are equipped with holding screws. For Installation and Removal instructions, please
see the section "Installing and Removing Terminal Boards with Holding Screws" later in this
chapter.
To install a terminal board (circled numbers refer to drawing below):
Figure 2-4. Installing an I/O Module's Terminal Board
GFK-0356Q Chapter 2 Installation
Hook the pivot hook , located on the bottom of the terminal board, to the lower slot on the
module.
Push the terminal board toward the module
Open the terminal board cover
the terminal board in place.
Compare the module catalog number on the label on the back of the hinged
door (see Figure 2-6) and the label on the side of the module (see below) to
ensure that they match. If a wired terminal board is installed on the wrong
module type, damage to the module may occur when the system is powered up.
Module
Label
REFER TO TEXT FOR
INSTALLATION PROCEDURE
until it snaps into place.
and ensure that the latch on the module is securely holding
Caution
2
1
2
a43062
3
2-5