GE 90-30 PLC Series Installation And Hardware Manual page 5

The Series 90-30 PLC and its associated modules have been tested and found to meet or exceed the
requirements of FCC Rule, Part 15, Subpart J. The Federal Communications Commission (FCC)
requires the following note to be published according to FCC guidelines.
This equipment generates, uses, and can radiate radio frequency energy and if not installed in
accordance with this instruction manual, may cause harmful interference to radio communications.
It has been tested and found to comply with the limits for a Class A digital device pursuant to Part
15 of the FCC Rules, which are designed to provide reasonable protection against harmful
interference when operated in a commercial environment. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to
correct the interference at his own expense.
The following note is required to be published by the Canadian Department of Communications.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the radio interference regulations of the Canadian Department of
Communications.
The following statements are required to appear in the Series 90_-30 Installation Manual and the
Series 90_-30 I/O Specifications Manual for Class I Div 2 Hazardous Locations.
1.
2.
3.
4.
GFK-0356Q
EQUIPMENT LABELED WITH REFERENCE TO CLASS I, GROUPS A, B, C, and D,
DIV. 2 HAZARDOUS LOCATIONS IS SUITABLE FOR USE IN CLASS I, DIVISION 2,
GROUPS A, B, C, D OR NON-HAZARDOUS LOCATIONS ONLY.
WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY
IMPAIR SUITABILITY FOR CLASS I, DIVISION 2:
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS
POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE
NON-HAZARDOUS.
ALL UNUSED SLOTS IN ALL BASEPLATES MUST BE POPULATED WITH FILLER
MODULES, IC693ACC310, OR EQUIVALENT.
RFI Standards
NOTE
NOTE
v