Slp Features; Memory; Installation - GE 90-30 PLC Series Installation And Hardware Manual

SLP Features

Memory

The SLP module has 46 Kbytes of user program memory space. Additional memory exists for
Input, Output, Register, and other variable data. The battery which supports this memory is
located on the SLP module, as shown in the following figure.

Installation

The module should power up and blink the top LED, indicating that power up diagnostics are in
progress. When the diagnostics have completed successfully the top LED stays on. The other
LEDs on this module are not used and will always stay off.
GFK-0356Q Chapter 9 State Logic Products
Natural English Language Programming using ECLiPS
Structured State Logic program architecture
Advanced Diagnostics
Simulation capabilities
PID Loop control
Handles complex math easily (floating point, square root, trig. functions)
Allows any combination of Natural English State Logic and Ladder Logic programs in same
system
Configurable to operate with a Series 90-30 PLC system that uses a model 33 , 340, or 34
CPU
Up to 5 2 inputs and 5 2 outputs
CCM2 Protocol
8 Mhz, 80C 88 microprocessor
46 Kbytes battery-backed CMOS logic memory on board
One RS-422/RS-485 port and one RS-232 serial port
Soft configuration (No DIP switches or jumpers)
Restart/Reset Pushbutton
OK Status LED
Occupies a single slot in a Series 90-30 rack
Installation should not be attempted without referring to the State Logic Processor User's
Guide (see reference ).
The Series 90-30 SLP can only be installed in a Series 90-30 PLC system that uses a model
33 , model 340, or model 34 CPU.
Make sure rack power is off.
Connect the battery to either of the battery connectors on the module (See figure E-3).
Install the SLP Module in the rack.
Turn on power.

9
9-5