Draytek Vigor2960 Series User Manual page 87

Item
Profile
Enable This Profile
Protocol
Address Type
Subnet
Object
Load Balance Pool
/WAN Profile
Vigor2960 Series User's Guide
Description
Type the name of the rule.
Check this box to enable such profile.
Choose a protocol (ALL, TCP, UDP, TCP/UDP, ICMP, FTP,
TFTP, HTTP, SMTP, POP3) for such rule applied to load
balance. All is the default setting.
Choose the address type (Subnet or Object) for such rule.
Each type will bring different settings for configuration.
Source IP Address - Type a WAN IP address here as the
source IP address for such rule.
– click the icon to clear the IP setting.
Source Mask - Use the drop down list on the right to choose
a suitable mask for the source.
Destination IP Address - Type a WAN IP address here as
the destination IP address for such rule.
– click the icon to clear the IP setting.
Destination Mask- Use the drop down list on the right to
choose a suitable mask for the destination.
Source IP Object – Use the drop down list to choose one of
the source IP objects for such rule profile.
Source IP Group –Use the drop down list to choose one of
the source IP group for such rule profile.
Destination IP Object – Use the drop down list to choose
one of the destination IP objects for such rule profile.
Destination IP Group - Use the drop down list to choose
one of the destination IP group for such rule profile.
Choose one of the profiles to be used by such rule. In which,
wan1 to wan5 profiles are configured in default. In addition,
profiles configured in WAN>>Load Balance Policy>> Pool
page also will be displayed here.
To have user-defined WAN profile, please refer to
WAN<<General Setup for detailed information.
79