Draytek Vigor2960 Series User Manual page 102

Default MAC
Address
MAC Address
IPv4 Protocol
Mode
IP Address
Subnet Mask
DHCP Server
DHCP Start IP
DHCP End IP
DNS
DHCP Routers
Enable – Click it to enable the default MAC address for such
profile.
Disable – Click it to type the MAC address manually for such
profile.
If Default MAC address is disabled, please specify a MAC
address manually.
Display the fixed type (static) for the IPv4 protocol for such
profile.
Choose NAT or ROUTING as the operation mode for such
profile.
Type the IP address of the router for the LAN profile.
Use the drop down list to choose a suitable mask for the LAN
profile.
Enable – Click it to enable the DHCP server. The DHCP
server will assign the IP address randomly for the LAN user.
The range of the IP addresses must be defined in DHCP Start
IP and DHCP End IP.
Disable – Click it to disable the DHCP server.
Type an IP address as the starting point for DHCP server.
Type an IP address as the ending point for DHCO server.
Set the private IP address for DNS server. If this field is
blank, users on LAN will treat Vigor2960 as the DNS server.
Add – Click it to add a new IP address for DNS server.
Save – Click it to save the setting.
– click the icon to remove the selected entry.
In general, this box will be blank. It means Vigor2960 will be
regarded as the gateway for the user.
However, if you want to use other gateway, please assign the
94
Vigor2960 Series User's Guide