Apply
Cancel
4.
After filling the required information for Basic, click the Advanced tab to open the
following page.
Available parameters are listed as follows:
Item
Aggressive Mode
Local Peer ID
Vigor2960 Series User's Guide
Key or RSA Signature. Choose PSK or RSA for such
profile.
Certificate - Choose a local certificate from the drop down
list if RSA is selected as Auth Type.
Preshared Key – Specify a key for IKE authentication if
PSK is selected as Auth Type.
Security Protocol – Choose ESP to specify the IPSec
protocol for the Encapsulating Security Payload protocol.
The data will be encrypted and authenticated. Choose AH to
specify the IPSec protocol for the Authentication Header
protocol. The data will be authenticated but not be
encrypted.
Click it to save the configuration.
Click it to exit the page without saving the configuration.
Description
Enable – Click it to enable Aggressive Mode.
Disable – Click it to disable Aggressive Mode.
Type the ID for Vigor2960 which can be configured by the
remote end. It is available for Aggressive Mode enabled
only.
261