If Dhcp Is Selected; If Pppoe Is Selected - Draytek Vigor2960 Series User Manual

I f D H C P i s s e l e c t e
I f D H C P i s s e l e c t e
DHCP allows a user to obtain an IP address automatically from a DHCP server on the
Internet. If you choose DHCP mode, the DHCP server of your ISP will assign a dynamic IP
address for Vigor2960 automatically. It is not necessary for you to assign any setting. (Host
Name is required for some ISPs).
Available parameters are listed as follows:
Item
Host Name (Optional)
Previous
Finish
Cancel
When you finished the above settings, please click Finish.
I f P P P o E i s s e l e c t
I f P P P o E i s s e l e c t
PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE
connection for accessing the Internet. Your service provider will provide you information
about user name, password, and authentication mode.
If your ISP provides you the PPPoE (Point-to-Point Protocol over Ethernet) connection,
please select PPPoE for this router to get the following page. Enter the username and
password provided by your ISP on the web page.
d
d
Description
Type a name as the host name for identification.
Click it to return to previous setting page.
Click it to finish the configuration.
Click it to discard the settings configured in this page.
e d
e d
12
Vigor2960 Series User's Guide