Draytek Vigor2960 Series User Manual page 68

Password
MTU/MRU
Service Name
Debug
Always On
Fixed IP
Connection
Detection Mode
Connection
Detection Host
Connection
Detection Interval
Connection
Detection Retry
Type the password offered by your ISP.
Type the value of MTU/MRU. The default value is 1492.
This is an optional setting. Some ISP will offer such
information and ask you to type the same data on this field.
Click Enable to display the PPPoE debug message in
Syslog. The default setting is Disable.
Enable – Click it to enable the function of Always On. The
router will keep network connection all the time.
Disable – Click it to disable the function of Always On.
Enable – Click it to enable the function of Always On. The
router will keep network connection all the time.
Disable – Click it to disable the function of Always On.
Fixed IP Address – Type an IP address here if you choose
Enable for Fixed IP.
Select a detecting mode for this WAN interface. There are
two ways PING and HTTP supported in Vigor router for
you to choose to send the request out.
If you choose PING/HTTP as Connection Detection Mode,
you have to specify the detection host address in this field.
Use the default setting.
Add – Click this button to have a field for adding a new IP
address. Assign an IP address or Domain name as a
destination to be detected whether the host is active (sending
reply to the router) or not. If not, the connection of WAN
interface will be regarded as breaking down. This function
is available when Connection Detection Mode is set with
PING or HTTP.
Save – Click this button to save the setting.
– Click the icon to remove the selected entry.
Assign an interval period of time for each detecting.
Assign detecting times to ensure the connection of the WAN
interface. After passing the times you set in this field and no
reply received by the router, the connection of WAN
60
Vigor2960 Series User's Guide