Table of Contents
Advertisement
Connecting the HRDV16/8 to Peripherals
Rev 1.00
Note
Formatting the hard drive will result in permanent loss of all images
and other information (for example, text and audio) recorded on the
hard drive.
In the event of an accidental Format All, go to the Data Recovery
screen to have the system attempt to restore the file system to its
original state (see
The message Attention! Any future changes to disk partitioning
b.
will require a FORMAT ALL and your recorded data will be
lost. Select OK.
The message Warning! This will delete all of the data on your
c.
drives! PROCEED? Select OK.
5.
Connect the HRDV16/8 to all the local peripherals, including cameras, monitors,
alarm inputs and outputs, external storage, and ATM/POS interface equipment (see
Connecting the HRDV16/8 to
6.
(Optional) Connect the HRDV16/8 to a PC via a modem, null modem, or Ethernet for
remote operation. For more information, refer to the
7.
Configure the HRDV16/8 for desired operation. See
detailed information, or see
setup procedure.
8.
Format the hard drive again (see
9.
To start recording, press REC on the HRDV16/8 front panel, then enter a user name
and password when prompted.
Figure 3-1
shows the rear panel connections on the HRDV16. Follow the instructions in
Table 3-1
to connect the HRDV16 to all peripherals.
Note
The HRDV8 rear panel looks the same as the HRDV16 except that it has 8
analog video inputs, 8 analog video outputs, and 8 alarm inputs.
Data
Recovery, page 53).
Peripherals).
Chapter 5, Easy Configurator
step 4
above).
15
HRDV Reference Guide
HRDV RAS User
Guide.
Chapter 4
to
Chapter 14
for
for an overview of the quick
Document 900.0261
04/05
Advertisement
Table of Contents
