Setting the Display Operation
Setting the Main Monitor Display
Rev 1.00
Display options are:
•
Full screen individual cameras—press each camera button (1 – 16)
•
Full screen sequence mode—press FUNCTION and Camera 1 together
•
Quad (2 x 2) mode—press FUNCTION and 4. Pressing again starts Quad page
sequencing
•
Nine (3 x 3) mode—press FUNCTION and 9. Pressing again starts Nine page
sequencing
•
Hex (4 x 4) mode—press FUNCTION and 16
•
One Spot monitor output (analog full screen). This output always sequences
whichever cameras are selected in the Display Setup menu at the specified dwell rate.
You cannot select an individual camera during the sequence and it does not display a
multiscreen display.
With V1.50 and later you can set certain cameras to appear as Disabled on the main
monitor and they do not appear in the spot monitor sequence.
Access the Display Setup screen as follows: MENU
Figure 15-3
displays.
Figure 15-3
Display Setup Screen
Set the main monitor switcher setup as follows:
1.
On the Display Setup menu, select Main Monitor to open the Main Monitor screen.
Figure 15-4
displays.
➤
System Setup
95
HRDV Reference Guide
➤
Display Setup.
Document 900.0261
04/05