Table of Contents
Advertisement
Daily Operation Overview
Buttons
Cam 1 to 16
REC (
)
PLAY ( )
▼
FUNCTION (
)
FUNCTION
+ Camera 1
FUNCTION
+ Camera 2
FUNCTION
+ Camera 3
FUNCTION
+ Camera 4
FUNCTION
+ Camera 9
FUNCTION
+ Camera 16
FUNCTION
+ PLAY ( )
Rev 1.00
Table 15-1
Front Panel Function Controls
Function
Selects a specific camera to be displayed on the main output monitor. Operation of
these buttons overrides the programmed operation of the main monitor.
•
Enables and disables (toggles) local recording to the hard drive
•
Use to navigate left through the menu structure
•
Use to select the previous clip during a play operation
•
Initiates the Go To Search feature, which populates the bottom half of the
monitoring screen. The top section continues to display video which changes as
you change the search criteria. See
Search Screen
on page
•
Use to navigate right through the menu structure
•
Use to select the next clip during a play operation
•
Activates secondary functions of the control buttons. This includes:
•
Accessing the multiscreen display modes
•
Sequencing
•
Searching
•
Generating reports without entering Menu mode
•
Use to navigate down through the menu structure
•
Use to decrement to a smaller value
Activates full screen camera sequence on main monitor
Activates the Hot Swap function. This allows you to remove the removable disk drive
without having to power down the HRDV16/8.
1. Press FUNCTION + Camera 2. This closes the device and displays a message
on the screen that it is okay to remove the device.
2. Remove the current device and insert a new one.
3. Press Enter.
Caution
Failure to properly activate this option may result in damaged
image clips.
Control any PTZ capable camera that is connected to your system. See
PTZ Camera
Operation, page 156.
Displays 2x2 images on main monitor. Press again to start Quad page sequencing.
Activating again selects next group (that is, 5 to 8).
For more information on Quad page sequencing, see
Displays 3x3 images on main monitor. Press again to start Nine page sequencing.
Activating again selects next group (that is, 10 to 15).
For more information on Nine page sequencing, see
Live mode: Displays 4x4 images on main monitor.
Setup mode: To set up motion detection zones:
1. Press the zone number (1 to 4).
2. Press FUNCTION + Camera 16 to fill/remove the zone number selected (1 to 4)
in the entire screen.
Activates the Search menu. Recording continues.
Searching for Video Clips with the Go To
105
for more information.
92
Controlling
Display
Setup, page 94.
Display
Setup, page 94.
Document 900.0261
04/05
Advertisement
Table of Contents
