Logging In And Viewing Live Video; Logging In To The Camera Via The Web Client; Before You Begin; Logging In To The Camera - Honeywell 30 Series Configuration Manual

Performance Series IP Camera Software Configuration Guide
3 Logging In and Viewing Live
Video
This chapter contains the following sections:
• Logging In to the Camera via the Web Client, page 6
• Using the Main Page, page 9

Logging In to the Camera via the Web Client

Using the web client, you can monitor live video, play back recorded video, and configure
camera settings.

Before You Begin

Before you log in to the web client, ensure that the following conditions are met:
• The camera is properly connected to the network.
• The camera's IP address and the PC's IP address are in the same network segment. If
there is a router, set the corresponding gateway and subnet mask.
• A network connection has been established. To check this, ping the camera's IP address.
(Enter "ping [IP address]").

Logging In to the Camera

Logging In via Internet Explorer
1. Open Internet Explorer, type the camera's IP address in the address bar, and then click
Enter. For example, if your camera's IP address is 192.168.1.108, you would type
https://192.168.1.108.
Note Internet Explorer 11 (or later) with ActiveX plug-in is supported.
2. The following window is displayed. Click Continue to this website (not recommended).
6