System Administration And Equipment Handling; Configuring Pins And Passwords - Honeywell ACUIX User Manual

System Administration and Equipment
Handling

Configuring PINs and Passwords

Document 800-05662V1 Rev A
04/11
This chapter contains the following sections:
• Configuring PINs and
• Resetting the Dome, page
• Restoring the Default
• Changing the Dome Address, Protocol, Parity, and Baud Rate
• Sending Commands to All
• Maintaining the Dome, page
To enable/disable the user login PIN:
1. Enter preset 75 on your controller.
2. Enter the 4-digit PIN. The default PIN is 1000.
3. Select 1 User Login PIN
To change the user login PIN:
1. Enter preset 75 on your controller.
2. Enter the 4-digit PIN. The default PIN is 1000.
3. Select 2 Change PIN.
4. Enter a new 4-digit PIN.
5. Re-enter the PIN to verify. If both PINs match, the message
displayed and the Password Settings menu opens.
Passwords, page 81
82
Settings, page 83
Domes, page 84
85

Enabled or Disabled (default).
11
Settings, page 83
PIN changed
is
81