Configuring Output Groups - Honeywell MPA2C3 User Manual

Table 2-11
Setting
Pulse Time
Latch
Interlocks
Energized
Disable Interlocks
8.

Configuring Output Groups

Note: You must select at least one output before you can create a group.
The Output Groups tab allows you to configure the following:
•
•
In the Output Groups tab, you can configure the following for one or more groups:
•
•
•
•
70
Description
Configure how long a device assumes abnormal status, such
as a horn sounding or a released door strike. In hours:min-
utes:seconds. Maximum time is 1:45:59.
Toggles the state of the outputs between energized and de-
energized status upon every activation (code use, interlock, or
manual pulse).
Disable/enable interlocks. See
more about Interlocks.
Specifies the period during which the output relay is automat-
ically energized. Select a schedule (that you created in
Panel Name
Specifies the period during which the interlocks that control
the output will be disabled. Select a schedule (that you cre-
ated in
down list.
Click Save.
A group of horns to sound for a set time during a set period
Energize or de-energize a group of doors during a set period
Pulse time
Disable/Enable Latch
Energized (schedule selection)
Disable Interlock (schedule selection)
section on page ) from the drop-down list.
42
section on page
Entering a Panel Name
Configuring Interlocks on page 53
) from the drop-
42
MPA2C3 User Manual
for
Entering a