Table of Contents
Advertisement
Creating an EVL
Configure other controllers as Secondary controllers by setting DIP switch 3 to
OFF. and Creating an EVL
Connect all Controllers to a common IP network. The Secondary IP controllers
must have DIP switch 3 set to OFF. and will be configured using the Primary con-
troller.
1. Log into MPA2C3 Primary panel from a browser through the USB2 -WEB
See
2. Navigate to Host/Loop Communications Screen:
•
•
Figure 2-2 Selecting Host/Loop Communication Tab
1. Set up Communication attributes (see
2. Log into the MPA2C3 panel.
MPA2C3 User Manual
MODE (https://192.168.2.150) or Ethernet connection Eth1 / PoE+ - HOST
(https://192.168.1.150 - SW1- Bit4 ON).
Setting Up the USB Connection
Menu > Panel Configuration > Host/Loop Communications, or
Click on Panels > Host/Loop Communications on the Dashboard.
a. Select Web as Host Connection Type.
b. Select Ethernet Virtual Loop as Mode.
c. Click Save. The panel automatically reboots.
section on page
for instructions.
6
figure 2-2
):
31
Advertisement
Table of Contents
