6. Power down; then power the panel back up. The RUN LED should flash normal.
7. The panel is now reset to the original factory default values.
Resetting the Panel
1. Navigate to the Settings panel:
Figure 1-2 Settings Panel
2. Click Reset.
Firmware Upgrades
Panel Requirements
MPA2C3 panels must first be upgraded to
information.
Note: The secondary (downstream) EVL panels should be upgraded first, and then the
primary (MASTER).
Overview
The following procedures provide step-by-step instructions for upgrading the
MPA2C3 controller.
MPA2C3 User Manual
• Dashboard > Panels > Settings, or
• Menu > Panel Configuration > Settings.
Click OK to reboot the panel.
. See
latest firmware
the release notes for more
135