Table of Contents
Advertisement
DIP Switch Settings (RS485 Mode)
IMPORTANT: Only 1 Primary controller may be in a RS-485 loop. All of the Sec-
ondary controllers must have DIP SW1, Bit 3 set to the OFF position.
controllers also need to be addressed with unique addresses by DIP SW1, Bit5 to Bit 9 in the cor-
rect positions in the below table.
DIP SW Settings Master Slave Mode RS485
1. Log into MPA2C3 Primary panel from a browser through Ethernet (Eth1 / PoE+
See
2. Navigate to Host/Loop Communications Screen:
•
•
3. Set up Communication attributes
4. Log into the MPA2C3 panel.
34
- HOST : default 192.168.1.150), or USB (USB2 - WEB MODE : 192.168.2.150).
Setting Up the USB Connection
Menu > Panel Configuration > Host/Loop Communications, or
Click on Panels > Host/Loop Communications on the Dashboard.
a. Select Web as Host Connection Type.
b. Select RS-485 as Mode.
c. Click Save. The panel automatically reboots.
on
. See
page 6
Setting Up an Ethernet Port
The secondary
on
.
page 8
MPA2C3 User Manual
Advertisement
Table of Contents
