Honeywell MPA2C3 User Manual page 44

Configuring the Current Panel Time
Between the Settings tab and the Host/Loop Communications tab, you can con-
figure the following for the current panel time:
Settings Tab
•
•
•
•
•
•
•
Host/Loop Communications Tab
•
•
•
Configuring Behavior Settings
•
44
Specify the time format (12 hour/24 hour).
Set a new date.
Set a new time.
Set the geographic time zone.
Enable a time server, and then specify the IP address of the time server being
used.
Specify the update interval.
Force a time synchronization between the panel and the time server.
Synchronizes the primary panel's time with the secondary panels.
In the Behavior Settings section of Panel Configuration, you can enable/disable
the following:
nted at an OUT reader must then be presented at an IN reader.
Enhanced Mode: When enabled, it tracks whether the card holder has actually
entered/used the door after presenting the card at IN/OUT sequence. If the card
holder did not used the door after presenting then in Alarms and Events
page,"Card Found Door Not Used" and "Card Found Door Used" events are
generated accordingly. If the user opens the door initially then "Card Found Door
Used" events are generated accordingly. If the user opens the door initentionally
then "Card Found Door Used" event is reported in Alams page for all the vaild
cards.
MPA2C3 User Manual