Configuring The Hardware - Honeywell IdentIPoint Installation Instructions Manual

CONFIGURING THE
HARDWARE
The LEDs at the back of the reader glow as follows when
power is applied to the device:
• Power - LED glows blue if power is applied to the reader.
• Activity - LED flashes amber when Ethernet cable is
connected and Ethernet is in communication; just remains
lit in other conditions.
• 10/100 - LED glows green when it is in 100M Ethernet
mode; remains unlit in all other conditions.
The LEDs on the front of the IOM glow as follows when power
is applied to the device:
o
Color
RED
LED
p
Power _
Data No
Comm.
Tamper _
IOM Address = 1
IOM Address = 3
Fig. 32. IOM Address set up - S3 Settings
Table 12. IOM LED States and Descriptions
BLINKING RED GREEN
_ _
Comm. exists All well
but invalid data.
Blinks when
there is
incoming invalid
data
Unit tampered _
HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM
IOM Address = 2
IOM Address = 4
BLINKING GREEN AMBER *
On main power _
Comm. exists with Installation
valid incoming data. state
Blinks when there is
incoming or outgoing
data
_ _
41
BLINKING AMBER * OFF
_ Off
Installation state. _
Blinks when there is
incoming or outgoing
data
_ Unit
OK
95-7767