Configuring Door Reader Settings
The Reader settings tab allows you to configure the following settings for both
Readers A and B for each door in a 2 door panel. In a 4 door system you can config-
ure settings in Wiegand mode only for Reader A (IN) and in OSDP mode for both
Reader A and B.
Below table explains the limitation on Reader type supported for 4 Door Controller
Table 2-4 Table 2-8 Limitations for 4 Door Controller
Reader Type Readers Supported for Door
OSDP
Wiegand
MPA2C3 User Manual
•
Door Name
•
Access Modes and Schedules
•
Anti-Passback (enable/disable)
•
Duress Output
Table 1:
Reader Type Readers Supported for Door
Reader A and B can be used for all the 4 Door
Only Reader A is available and Reader B is
disabled
55