Configuring Access Groups - Honeywell MPA1 User Manual

Configuring Access Groups

Every card is assigned an access group, which specifies the schedule, or time schedule,
during which the card holder can be granted access at a specific door. For example, an
access group embedded in an employee's card might allow the employee to enter the
facility only through door 2 from 6:00 AM to 6:00 PM, Monday through Friday.
On the Access Groups panel, you can:
To navigate to the Access Configuration page, click:
•
•
• Select Reader A and/or Reader B for each door. Note that if a reader is disabled,
then the schedule drop down list for that reader will not be accessible.
• Create an access group.
• Modify an access group.
• Delete an access group.
• Set a Schedule for each door.
• View other panels with readers in this access group.
Note Since an access group is defined by door and schedule configurations, you
must configure the door (see
Configuring People on page
Name on page 28) before configuring an access group.
Menu > Configuration > People & Access > Access > Create an Access Group, or
Access Groups in the Dashboard, then Create an Access Group.
Figure 2-44 Access Group Configuration Page
Configuring Doors on page
66), and the schedule (see
Document 800-26311_ A - April 2020
| 73
42), people (see
Entering a Panel