Honeywell MPA2C3 User Manual page 65

Configuring Discription
Name
Pulse Time
Latch
TZ Card Toggles
First Card Rule
3. Select Scheduling
Configuration
Energized
Disable Interlocks
4. Click Save.
MPA2C3 User Manual
Enter a unique name to identify the lock output
Configure how long a device assume to be normal status such as a hours,
minutes and seconds, Maximum time is 1:45:59
Toggle the start of the outputs between energized and de-energized upon
every activation (code use, interlock, or manual pulse) Interlocks Disable/
enable interlocks. See Interlock
information about Interlocks
Requires like the First Card Rule, a valid card read within the time zone to
enable the time zone (periods in which the doors are unlocked) to take
effect. Unlike the First Card Rule, however the user can swipe the card a
second time to return the doors to a locked
Note: Effective only if the output has a valid schedule for Energized in
the Section Scheduling. Both TZ Card Toggle and First Card Rule
cannot be enabled at the same time
First Card Rule requires a valid card read within the time zone to enable
the time zone (period in which the doors are unlocked) to take effect.
Note: Effective only if the output has a valid schedule for Energized in
the section Scheduling. Both TZ Card Toggle and First Card Rule
cannot be enabled at the same time.
Description
Specifies the period during which the output relay is automatically
in the state where the door is unlocked (Energized or De-
energized-when FACP is in use).
Select the Schedule (that you created in
Schedules, page 45from the drop down list. The Energized state of
the output can be affected by the Enabled setting for the TZ Card
Toggle or First Card R
Specifies the period during which the Interlock that controls the
output will be disabled, Select a Schedule (that you created in
Configuring Schedules, page 45from the dropdownlist.
Configuration, page 77 for more
Configuring
65