Configuring Outputs - Honeywell MPA2C3 User Manual

Table 2-10
Configuration
Disable Alarm
Messages
Click Save.

Configuring Outputs

In the Individual Outputs tab, you can configure the following for each output:
•
•
•
1. Navigate to the Outputs tab: Click Panel Configuration
2. Click to select an individual output from the list.
3. Configure the following for each output:
Table 2-11
Setting
Name
MPA2C3 User Manual
Description
Specifies the time period during which Alarm and Normal will not
be reported, but Short and Cut will be reported. Short alarms are
triggered when a short occurs in the system. Cut alarms are
triggered when a wire is cut.
Pulse time
Disable/Enable Latch and Interlocks
Energized and Disable Interlocks schedules
Figure 2-2 Configuring Individual Outputs
Description
Enter a unique name for the output
Outputs Individual
> >
69
.