Table of Contents
Advertisement
4. Configure Shunt and Debounce times.
Table 2-7
Configura-
tion
Shunt Time
(h:m:s)
Debounce
Time (h:m:s)
5. Configure Scheduling.
Configuration
Shunt
Disable
Interlocks
Disable
Alarm Mes-
sages
6. Click Save.
Configuring Door Outputs
The Outputs tab allows you to configure the following settings:
1. Discrete or Group selection
2. Output Name and Pulse Duration
3. Latch and Interlocks
4. Special output modes controlled by cards
MPA2C3 User Manual
Description
Specifies the amount of time for which the inputs
are shunted, or de-activated. The maximum length
of time is 1 hour, 45 minutes, 59 seconds.
You can express seconds in tenths of a second.
Specifies the period of time (MIN = 0 second, MAX =
6553.5 seconds) the input must remain in a new
state before generating an alarm. For example, with
a 5-second debounce time selected, if a Normal
state is changed to Alarm, the state must remain in
Alarm for five consecutive seconds before an alarm
is generated.
Table 2-1
Description
Specifies the time period during which the input will
be ignored.
Specifies the time period during which the pro-
grammed action on this input from another point
will be disabled.
Specifies the time period during which Alarm and
Normal will not be reported, but Short and Cut will
be reported. Short alarms are triggered when a
short occurs in the input cable. Cut alarms are trig-
gered when a wire is cut.
63
Advertisement
Table of Contents
