Configuring Door Outputs - Honeywell MPA1 User Manual

50 |
MPA1 User Guide

Configuring Door Outputs

The Outputs tab allows you to configure the following settings:
1.
2.
3.
4.
5.
6.
Two outputs are associated with the door on a MPA1 panel
1.
2.
The Outputs tab allows you to configure the following settings for the door
1.
2.
3.
4.
5.
6.
7.
8.
Click Outputs in the Doors configuration window to open the outputs configuration pane
www.honeywell.com/security
Discrete or Group selection
Output Name and Pulse Duration
Latch and Interlocks
Special output modes controlled by cards
Lock operation definition
Scheduling
Lock- Controls the lock in an electronic state to open or close the door (Default SWITCHED GND)
Reader LED-Controls the LED of the Reader(s) in Green state (via OSDP command)
Select Discrete Output or Output Group and number
Define Output Name
Specify Pulse duration
Disable or Enable Latched output after valid card (instead of pulse)
Disable or Enable Interlocks.
Disable or Enable Card activity outputs mode such as Time Zone Card Toggle and
First Card Rule
Specify Lock Operation as Fail Safe or Fail Secure
Specify Schedules for Energized output and for Disable Interlocks
Figure 2-27 Door Output Configuration Interface.