Powering Off The System; Replacing The New Primary Codec - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Chapter 5 Upgrading a Cisco TelePresence System 3000 to a Cisco TelePresence System 3200

Powering Off the System

To power off the system, complete the following steps.
Step 1 Get the IP address for the primary codec by completing the following steps:
a.
Note
b.
c.
Open a browser on a computer that is connected to the network.
Step 2
In the URL field, type the IP address for the primary codec and press Enter. The browser launches the
Step 3
Cisco TelePresence System Administrator.
Log in to the system by entering the following information:
Step 4
a.
b.
Note
Click Login.
Step 5
Locate the Phone pane in the upper left-hand corner of the administrator page and select
Step 6
Troubleshooting > System Reset. The Restart Cisco TelePresence System button appears at the top of
the window.
Click the Restart Cisco TelePresence System button to start the reset.
Step 7
Six check boxes display on the lower right corner of the center display screen.
After the first box changes to a check mark, turn the power switches for the following units to the Off
Step 8
position:
•
•
•

Replacing the New Primary Codec

To replace the existing primary codec with the new primary codec, complete the following steps:
Remove all cable ties holding the cables to the cable management bar. Take note of the organization of
Step 1
the cables.
Remove the cables from the codec. Label each cable with masking tape for identification as it is
Step 2
removed.
Remove and retain the screws that attach the codec's L-brackets to the Display structure Front feet.
Step 3
OL-16441-01
On the IP phone, locate Manual at the bottom of the screen and press the Manual soft key.
If you cannot locate the Manual button, proceed to Step
Locate Info at the bottom of the screen and press the Info soft key.
Scroll down to the IP Address listing and copy the address.
In the Admin field, type admin.
In the Password field, type cisco.
If your administrator has changed the user name or password, enter those values.
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
If present, the PDU on the center display structure
Powering Off the System
b.
Cisco TelePresence System
5-3