Cisco 7800 Series Administration Manual page 76

Provisioning
Provisioning
Phones can be provisioned to download configuration profiles or updated firmware from a remote server when
they are connected to a network, when they are powered up, and at set intervals. Provisioning is typically part
of high-volume, Voice-over-IP (VoIP) deployments and is limited to service providers. Configuration profiles
or updated firmware are transferred to the device through use of TFTP, HTTP, or HTTPS.
The Cisco IP Phone 7800 Series and 8800 Series for Third-Party Call Control Provisioning Guide describes
provisioning in detail.
Web-Based Configuration Utility
Your phone system administrator can allow you to view the phone statistics and modify some or all the
parameters. This section describes the features of the Cisco IP Phone that you can modify with the phone web
user interface.
Access the Web-Based Configuration Utility
Access the Cisco IP Phone configuration utility from a web browser on a computer that can reach the phone
on the subnetwork.
Procedure
Step 1 If the computer is connected to a VPN, exit the VPN.
Step 2 Launch a web browser.
Step 3 Enter the IP address of the phone in your web browser address bar.
For example,
Note
Determine the IP Address of the Phone
A DHCP server assigns the IP address, so the phone must be booted up and connected to the subnetwork.
Procedure
Step 1 Click Admin Login > advanced > Info > System Status.
Step 2
Scroll to System Information. Current IP displays the IP address.
Cisco IP Phone 7800 Series for Third-Party Call Control Administration Guide
62
http://10.64.84.147
If your service provider disables access to the configuration utility, contact the service provider to
proceed.