Cisco 7800 Series Administration Manual page 160

Cisco IP Phone Web Page
Parameter
Log Failure Msg
User Configurable Resync
Firmware Upgrade
Parameter
Upgrade Enable
Upgrade Error Retry Delay
Upgrade Rule
Enable Enterprise Image Upgrade
For information about the Provisioning page, see the Cisco IP Phone 7800 Series and 8800 Series for
Third-Party Call Control Provisioning Guide.
Cisco IP Phone 7800 Series for Third-Party Call Control Administration Guide
146
Description
The syslog message that is issued after a failed download attempt.
Default:
$PN $MAC -- %s failed: $ERR
Allows a user to resync the phone from the phone screen.
Default: Yes
Description
Allows firmware update operations independent of resync actions.
Default: Yes
The interval applied in the event of an upgrade failure. The firmware
upgrade error timer activates after a failed firmware upgrade attempt
and is initialized with this value. The next firmware upgrade attempt
occurs when this timer counts down to zero.
Default: 3600 seconds
A firmware upgrade script that defines upgrade conditions and associated
firmware URLs. It uses the same syntax as Profile Rule.
Use the following format to enter the upgrade rule:
protocol://server[:port]/profile_pathname
For example:
tftp://192.168.1.5/image/sip88xx.10-3-1-9-3PCC.loads
If no protocol is specified, TFTP is assumed. If no server-name is
specified, the host that requests the URL is used as the server name. If
no port is specified, the default port is used (69 for TFTP, 80 for HTTP,
or 443 for HTTPS).
Default: Blank
The Cisco IP Phone also supports a single image upgrade from 3PCC
image to enterprise image.
Default: No
After upgrade to enterprise image, the phone cannot revert to
Note
3PCC.