Cisco 7800 Series Administration Manual page 158

Cisco IP Phone Web Page
Provisioning
Configuration Profile
Parameter
Provision Enable
Resync On Reset
Resync Random Delay
Resync At (HHmm)
Resync At Random Delay
Resync Periodic
Resync Error Retry Delay
Cisco IP Phone 7800 Series for Third-Party Call Control Administration Guide
144
Description
Allows or denies resync actions.
Default: 160,159,66,150
The device performs a resync operation after power-up and after each
upgrade attempt when set to Yes.
Default: Yes
A random delay following the boot-up sequence before performing the
reset, specified in seconds. In a pool of IP Telephony devices that are
scheduled to simultaneously powered up, this introduces a spread in the
times at which each unit sends a resync request to the provisioning
server. This feature can be useful in a large residential deployment, in
the case of a regional power failures.
Default: 2
Time in 24-hour format (hhmm) to resync the device. When this
parameter is provisioned, the Resync Periodic parameter is ignored.
Default: Blank
To avoid flooding the server with simultaneously resync requests from
multiple phones set to resync at the same time, the phone triggers the
resync up to ten minutes after the specified time.
The input value (in seconds) is converted to minutes.
The default value is 600 seconds (10 minutes). If the parameter value
is set to less than 600, the default value is used.
Default: 600
Time in seconds between periodic resyncs. If this value is empty or
zero, the device does not resync periodically.
Default: 3600
If a resync operation fails because the IP Telephony device was unable
to retrieve a profile from the server, if the downloaded file is corrupt,
or an internal error occurs, the device tries to resync again after a time
specified in seconds.
If the delay is set to 0, the device does not try to resync again following
a failed resync attempt.
Default: 3600