Cisco 7800 Series Administration Manual page 43

Set DHCP Enabled Field
Procedure
Step 1
Press Applications
Step 2 Select Admin Settings.
Step 3 Scroll to Network Setup, select IPV4 Setup.
Step 4
Scroll to the DHCP Enabled option.
Step 5 Press Edit.
Step 6 Press Disable to disable DHCP, or press Enable to enable DHCP.
Step 7
Press Back .
Set IP Address Field
Procedure
Step 1
Press Applications
Step 2 Select Admin Settings.
Step 3 Scroll to Network Setup, select IPV4 Setup.
Step 4
Set the DHCP Disabled option to Disable.
Step 5
Press , scroll to the IP Address option, press Edit, and enter a new IP Address.
Step 6
Press Validate, and then press Apply to apply the changes; or press Revert to discard the changes.
What to Do Next
You must set the Subnet Mask Field and the Gateway.
.
.
Cisco IP Phone 7800 Series for Third-Party Call Control Administration Guide
Configure Network Settings
29