Cisco IP Phone Web Page
Parameter
Daylight Saving Time Rule
(continued)
Daylight Saving Time Enable
Localization
Parameter
Dictionary Server Script
Language Selection
Locale
Cisco IP Phone 7800 Series for Third-Party Call Control Administration Guide
150
Description
The <weekday> value equals any value in the range 1-7
(Monday-Sunday). It can also equal 0. If the <weekday> value is 0, this
means that the date to start or end daylight saving is exactly the date
given. In that case, the <day> value must not be negative. If the
<weekday> value is not 0 and the <day> value is positive, then daylight
saving starts or ends on the <weekday> value on or after the date given.
If the <weekday> value is not 0 and the <day> value is negative, then
daylight saving starts or ends on the <weekday> value on or before the
date given. Where:
• HH stands for hours (0-23).
• mm stands for minutes (0-59).
• ss stands for seconds (0-59).
Default: 3/-1/7/2;end=10/-1/7/2;save=1.
Enables Daylight Saving Time.
Default: Yes
Description
Defines the location of the dictionary server, the languages available,
and the associated dictionary. See the
57.
Default: Blank
Specifies the default language. The value must match one of the
languages supported by the dictionary server. The script (dx value) is:
<Language_Selection ua="na">
</Language_Selection>
Default: Blank
The maximum number of characters is 512. For example:
<Language_Selection ua="na"> Spanish
</Language_Selection>
Choose the locale that should be set in the HTTP Accept-Language
header
Default: en-US
Dictionary Server Script, on page