Honeywell Marathon User Manual page 52

Wireless Zero Config Utility
• The WZC utility has an icon in the toolbar indicating the Wireless Zero Config application is enabled
but the connection is inactive at this time (the device is not connected to a network). The WZC icon
may not be visible until control is passed to the WZC utility as described below.
• You can use either the Wireless Zero Configuration Utility or the Laird Configuration Manager to
connect to your network. The Laird Configuration Manager is recommended because the Wireless
Zero Configuration Utility cannot control the complete set of security features of the radio.
To Switch Control to the Wireless Zero Config Utility
1. Select Configuration > Manage Profiles > Globals.
2. Change the value for the Supplicant property value to Third Party.
3. Tap Commit.
4. Restart the Marathon.
The Laird Connection Manager passes control to Wireless Zero Config and the WZC Wireless Information control
panel. Using the options in the Wireless Zero Config panels, set up radio and security settings. There may be a
slight delay before the Wireless Zero Config icon indicates the status of the connection.
The
To Switch Control to LCM
1. To switch back to LCM control, select Configuration > Manage Profiles > Globals.
2. Change the value for the Supplicant property value to Laird.
3. A message appears that a Power Cycle is required to make settings activate properly.
4. Tap Commit.
5. Restart the Marathon.
Radio control is passed to the LCM.
6 - 2