Pre-Configured Default Values - Honeywell Marathon User Manual

Pre-Configured Default Values

Parameter
Set Default Parameter
Parameter Scanning
Operational Mode
Beep After Good Decode
Beeper Tone
Beeper Volume
Decode Session Timeout
Power Mode
Presentation Mode Session Timeout
Report Version
Time Delay to Low Power Mode
Picklist Mode
Decode Mirror Images (Data Matrix Only)
Imager Preferences Options
Operational Mode
Decoding Illumination
Decode Aiming Pattern
Decoding Autoexposure
LED Illumination
Image Capture Autoexposure
Image Capture Illumination
Trigger Modes
Fuzzy 1D Processing
Timeout Between Decodes, Same Symbol
Focus Mode
Miscellaneous Imager Options
Scan Data Transmission Format
Transmit "No Read" Message
Transmit Code ID Character
Prefix / Suffix Values
SSI Prefix Value
SSI Suffix 1 Value
SSI Suffix 2 Value
Simple Serial Interface (SSI) Host Parameters
Event Reporting
USB Host Parameters
Serial Host Parameters
UPC/EAN
UPC-A
UPC-E
UPC-E1
EAN-8/JAN 8
13 - 6
Default Value
All Defaults
Enable
Decode Mode
Enable
Medium
High
9.9 sec
Low Power
2 sec
Current Software Version
1 sec
Disabled Always
Never
Decode Mode (no bar code available)
Enable
Enable
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Data As Is
Disable
None
<CR>
<CR>
<CR>
Not Supported
Not Supported
Not Supported
Not Supported
Enable
Enable
Disable
Enable