CE Mark
The CE marking indicates compliance with the following directives:
• 1995/5/EC R&TTE
• 2011/65/EU RoHS (Recast)
In addition, complies to 2006/95/EC Low Voltage Directive, when shipped with recommended power supply. European contact:
Hand Held Products Europe BV
Nijverheidsweg 9-13
5627 BT Eindhoven
The Netherlands
Honeywell shall not be liable for use of our product with equipment (i.e., power supplies, personal computers, etc.) that is not CE
marked and does not comply with the Low Voltage Directive.
RF Notices
Warnings:
FCC/IC RF Radiation Exposure Statement:
1. This Transmitter has been demonstrated co–location compliance requirements with Bluetooth/WLAN antenna, FCC ID:
KDZLXE-FX1; IC: 1995B-LXEFX1 WWAN antenna, FCC ID: KDZLXE-FX1WW; IC: 1995B-FX1WW.
2. This equipment complies with FCC/IC RF radiation exposure limits set forth for an uncontrolled environment. This device
was tested for typical lap/hand held operations with the device contacted directly to the human body to the back, front, and
left side of the Handheld Computer.
To maintain compliance with FCC/IC RF exposure compliance requirements, avoid direct contact to the transmitting antenna
during transmission.
Bluetooth
Class II
Honeywell Scanning & Mobility Product Environmental Information
Refer to
www.honeywellaidc.com/environmental
Dealer License - Republic of Singapore
Vehicle Power Supply Connection Safety Statement
Vehicle Power Supply Connection: If the supply connection is made directly to the battery, a 10A slow-blow fuse should be
installed in the positive lead within 5 inches (12.7 cm) of the battery positive (+) terminal.
for the RoHS / REACH / WEEE information.
1 - 3