Desktop Dock Maintenance; Desktop Dock Cleaning - Honeywell Marathon User Manual

Issue
Marathon docked but
cannot work with
accessory cables
connected to dock.
Marathon docked but
Docked LED does
not light up.

Desktop Dock Maintenance

Inspect the rubber feet and replace them if missing, broken or cracked. Check the dock regularly for excessive wear at pres-
sure points. If the dock is mounted to a stable surface, check surface mounting connections periodically and re-tighten as
necessary.
If the dock becomes cracked or broken at any time, it must be taken out of service and replaced. Contact
(page 14-1) for a replacement dock.
There are no serviceable parts in the desktop dock. Do not attempt to open the unit.

Desktop Dock Cleaning

Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the surfaces and/or
battery charging terminals (pins).
Use a clean soft cloth to wipe any dirt, moisture or grease from the Marathon, extended batteries, charging contacts (pins)
and the dock.
Do not use any liquid to clean the extended battery, Marathon, dock, or charging bays. Spray or dampen the cleaning cloth
with liquids/sprays. If possible, clean only those areas which are soiled.
Lint/particulates can be removed from the connectors, charging terminals and charging/docking bays with clean, filtered
canned air.
11 - 8
Cause
Marathon not fully seated in dock.
Foreign objects inside docking bay or cable
connectors.
Marathon not fully seated in dock.
Power supply not connected.
Solution
Reseat the Marathon fully into the docking bay.
Remove the foreign objects and reseat the
Marathon into the docking bay.
• Check the docking bay is clear of foreign
objects and reseat the Marathon fully into the
docking bay
• Check that power is applied to the Power
Jack at the rear of the Dock.
Customer Support