Chapter 1 - Marathon Agency Compliance; Laser Warnings; Laser Label Location; Laser Safety Statement - Honeywell Marathon User Manual

1
Marathon Agency Compliance
Marathon computers meet or exceed the requirements of all applicable standards organizations for safe operation. However, as
with any electrical equipment, the best way to ensure safe operation is to operate them according to the agency guidelines that
follow. Read these guidelines carefully before using your Marathon.
This documentation is relevant for the following model: Marathon Field Computer.
Caution:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. The battery should be disposed
of by a qualified recycler or hazardous materials handler. Do not incinerate the battery or dispose of the battery
with general waste materials.

Laser Warnings

Note: A 2D Imager Add-on module may be attached to the Marathon. Laser warnings and labels that follow are specifically for
a Marathon with a 2D Imager.
If the following label is attached to your product, it indicates the Marathon contains an engine with a laser aimer:
• Do not look into the laser's lens.
• Do not stare directly into the laser beam.
• Do not remove the laser caution labels from the Marathon.
• Do not connect the laser bar code aperture to any other device. The laser bar code aperture is certified for use with the
Marathon only.
Caution:
Laser radiation when open. Please read the caution labels. Use of controls, adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.

Laser Label Location

Laser Safety Statement

This device has been tested in accordance with and complies with IEC60825-1 ed2 (2007). Complies with 21 CFR 1040.10 and
1040.11, except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
LASER LIGHT, DO NOT STARE INTO BEAM, CLASS 2 LASER PRODUCT, .0 mW MAX OUTPUT: 630-680nM.
Model Number, Serial Number and IMEI Labels
The model (item) number, serial number, and international mobile equipment identity (IMEI, if applicable) number for the
terminal are located on labels affixed to the back of the terminal.
If the following label is attached to your product, it indicates the
Marathon contains an engine with a laser aimer.
1 - 1