Remote Antenna Installation Kit - Honeywell Marathon User Manual

Ethernet/USB Port
This port accepts the USB/Ethernet adapter. The adapter is a 3 port dongle containing a standard RJ45 Ethernet con-
nector and two standard USB host connectors. Connecting an Ethernet cable to the Ethernet cable end provides a
Gigabit Ethernet connection. When a LAN connection is made via Ethernet cable, the appropriate LAN LED on the
front of the dock is illuminated. A second LAN LED indicates LAN activity.
Any USB client device can be connected to the Marathon in the vehicle dock using the 3 port adapter USB ends.
Antenna Connectors
Connect the antenna to the appropriately marked antenna port.
Strain Relief Cable Clamps
Left Set
Six Strain Relief Cable Clamps are located on the back of the vehicle dock, 3 on each side.
Equipment required: Phillips screwdriver, not supplied.
Procedure
1. Remove the strain relief cable clamp from the back of the dock by turning the screw counterclockwise. Put the
screw aside in a safe location.
2. Slide the strain relief clamp over the cable.
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the vehicle
dock. Do not stretch the cable. Leave enough slack in the cable to allow the cable to be connected and discon-
nected from the Marathon vehicle dock easily when needed.
4. Continue in this manner until all cables are secured to the back of the vehicle dock.

Remote Antenna Installation Kit

The external GPS antenna is an adhesive mount antenna.
The Remote Antenna Installation Kit consists of the antenna and an integrated cable. The remote antenna is mounted on
the top of a forklift, truck or other vehicle and cabled to the Marathon dock inside the vehicle.
1. Locate a mounting position on the highest point on the vehicle, following this precaution: The antenna must be mounted
so the antenna is not damaged while the vehicle or any of its parts are moving.
2. Clean the area where the antenna is to be mounted.
3. Remove the protective backing paper from the adhesive on the antenna and position the antenna on the vehicle.
4. Attach the connector on the coaxial cable to the antenna connector on the vehicle mounted Marathon dock.
5. Use cable ties to secure the coaxial cable to the vehicle as necessary. Make sure the cable is routed so it is not
damaged by any moving parts of the vehicle.
Right Set
11 - 17