Honeywell Marathon User Manual page 181

Mounting Dimensions
Note: Drill and tap holes for 1/4 bolts.
Not To Scale
Step 2 – Attach RAM Mount Ball to the Marathon Vehicle Dock
1. Place the vehicle dock face down on a stable surface.
2. Position the RAM ball bracket on the rear of the vehicle dock, aligning the holes on the back of the vehicle dock with
the holes on the RAM ball mount bracket.
3. Attach with four screws and lock washers.
Step 3 – Attach Vehicle Dock to RAM Mount
1. Slip the RAM arm over the ball on the vehicle RAM mount.
2. Insert RAM ball on the dock into the RAM arm.
3. Adjust the Marathon to the desired position and tighten the knob on the RAM arm using the supplied RAM wrench.
Step 4 - Place Marathon in the Vehicle Dock
1. Lower the Marathon into the docking bay until it is seated and then push it back into the dock. The release mecha-
nisms will slide out of the way, and then spring forward, securing the Marathon in the vehicle dock.
2. Ensure the charging contacts at the base of the Marathon are seated on the charging contacts in the docking bay.
After power is applied to the vehicle dock, the Battery LED on the Marathon will illuminate amber, indicating the battery
in the Marathon is recharging using vehicle power.
To remove the Marathon, press down and out on the release mechanisms until the Marathon is released. Lift the
Marathon straight up out of the dock.
Note: Do not "slam" or slide the Marathon sideways into the dock. Damage may result.
11 - 13