Attaching The Hand Strap - Honeywell Marathon User Manual

Attaching the Hand Strap

Components:
• Long Hand Strap, approximately 7.4"/18.8 cm without loop
• Short Hand Strap, approximately 4.0"/10.2 cm without loop
• Strap Buckle
• Screws, strap attaching
The hand strap is designed to be used with the Marathon with or without an extended battery attached. The hand strap is
designed so the Marathon can be mounted in the desktop dock or the vehicle dock without removing the hand strap.
1. Place the Marathon with the screen facing down, on a flat stable surface.
2. Remove any of the plugs by unscrewing them in a counter-clockwise direction. Remove only the plugs necessary to mount
the hand strap. See the illustration below for possible hand strap orientations.
:
3. Insert the Strap Attaching Screws into the appropriate holes. These screws have an eye to attach the strap.
4. Thread the nylon loop of the Strap Buckle through one of the Strap Attaching Screws from the outside edge. Then thread the
buckle end of the strap through the loop and pull tight.
5. The hand strap kit contains two straps. Use the longer strap for a horizontal or diagonal mount and use the shorter strap for
the vertical mount. Thread the nylon loop of the appropriate strap through the other Strap Attaching Screw. Then thread the
strap through the loop and pull tight.
6. Making sure the closed loop fastener surface on the hand strap is facing up, slide the strap through the latch in the top clip.
7. Fold the end of the strap over so that the closed loop fastener surfaces mate evenly and the hand strap is secured to the
Marathon.
8. Test the strap's connection making sure the Marathon is securely connected to each end of the strap connectors.
2 - 9