Decode Upc/Ean/Jan Supplementals - Honeywell Marathon User Manual

Decode UPC/EAN/JAN Supplementals

Supplementals are bar codes appended according to specific format conventions (e.g., UPC A+2, UPC E+2, EAN 13+2).
The following options are available:
Option
Decode UPC/EAN/JAN Only with
Supplementals
Ignore Supplementals
Autodiscriminate UPC/EAN/JAN
Supplementals
If one of the following Supplemental Mode options is selected, the bar code reader immediately transmits EAN-13 bar
codes starting with that prefix that have supplemental characters. The bar code reader transmits UPC/EAN bar codes that
do not have that prefix immediately.
Option
Enable 378/379 Supplemental Mode
Enable 978/979 Supplemental Mode
Enable 977 Supplemental Mode
Enable 414/419/434/439 Supplemental
Mode
Enable 491 Supplemental Mode
Enable Smart Supplemental Mode
Supplemental User-Programmable Type 1
Supplemental User-Programmable Type 1
and 2
Smart Supplemental Plus User-
Programmable 1
Smart Supplemental Plus User-
Programmable 1 and 2
Supplemental User-Programmable 1
Supplemental User-Programmable 2
Note: In order to minimize the risk of invalid data transmission, select whether to read or ignore supplemental characters.
Select an option by scanning one of the bar codes shown below. If you wish to change your selection, scan the Cancel bar
code and scan again.
13 - 34
Result
The bar code reader only decodes UPC/EAN symbols with supplemental
characters, and ignores symbols without supplementals.
The bar code reader decodes UPC/EAN and ignores the supplemental
characters.
The bar code reader decodes UPC/EAN symbols with supplemental
characters immediately. If the symbol does not have a supplemental, the
bar code reader must decode the bar code the number of times set via
UPC/EAN/JAN Supplemental Redundancy" before transmitting its data to
confirm that there is no supplemental.
Result
---
If 978 Supplemental Mode is selected and the decoder is scanning
Bookland EAN bar codes, see
Bookland EAN, and select a format using
13-33).
---
---
---
Applies to EAN-13 bar codes starting with any prefix listed previously.
Applies to EAN-13 bar codes starting with a 3-digit user-defined prefix.
Set this 3-digit prefix using Supplemental User-Programmable 1.
Applies to EAN-13 bar codes starting with either of two 3-digit user-
defined prefixes. Set the 3-digit prefixes using Supplemental User-
Programmable 1 and Supplemental User-Programmable 2.
Applies to EAN-13 bar codes starting with any prefix listed previously or
the user-defined prefix set using Supplemental User-Programmable 1.
Applies to EAN-13 bar codes starting with any prefix listed previously or
one of the two user-defined prefixes set using Supplemental User-
Programmable 1 and Supplemental User-Programmable 2.
Select Supplemental User-Programmable 1 to set a 3-digit prefix. Then
select the 3 digits using Imager Keypad Number Symbols
Select Supplemental User-Programmable 2 to set a second 3-digit prefix.
Then select the 3 digits using
84).
Bookland EAN (page 13-32) to enable
Bookland ISBN Format
Imager Keypad Number Symbols
(page
(page 13-84).
(page 13-