Report Version - Honeywell Marathon User Manual

This parameter determines how long the decoder will attempt to decode a bar code before determining if it is a good read
or a bad read.
Presentation Mode means the decoder is always On and will scan bar codes that enter its field of view. Presentation Mode
applies to Decode Mode only.
To set the duration of the attempt to decode a bar code detected in presentation mode, scan the Presentation Mode Ses-
sion Timeout bar code below. Default = 2 Seconds.
Next scan three numeric bar codes on Imager Keypad Number Symbols (page 13-84) to select a value between 1 and 255
that represents tenths of a second. Single digit numbers must have a leading zero.
For example, to set 0.5 seconds, scan the Presentation Mode Session Timeout bar code, then scan the 0, 0, 5 bar codes
on Imager Keypad Number Symbols. To correct an error or change the selection, scan the Cancel bar code and try again.

Report Version

Scan the following bar code to view the version of software currently installed in the decoder. The result is displayed on
the host device screen.
13 - 17