Docking / Undocking; Vehicle Dock Mounting Procedure - Honeywell Marathon User Manual

Docking / Undocking

Place the Marathon in the Vehicle Dock
Lower the Marathon into the docking bay until it is seated and then push it back into the dock. The release mechanisms
will slide out of the way, and then spring forward, securing the Marathon in the vehicle dock.
Removing the Marathon from the Vehicle Dock
To take the Marathon out of the dock, press down and out on the release mechanisms and the unit will spring forward
out of the dock. Pick the unit up and out of the dock.

Vehicle Dock Mounting Procedure

Note: As there are many different RAM Mounting Brackets available, the following diagrams are representations, not the
actual image.
Required: Phillips No. 1 screwdriver and a Torque wrench capable of measuring to 50 inch pounds (5.64±.56 N/m).
Note: Torquing tool is not supplied. Tools needed to attach the RAM Clamp Mount to the vehicle are not supplied.
Torque Measurement
You will need a torquing tool capable of torquing to 20 inch pounds (1.10 N/m). Torque all screws and bolts according
to the following table:
For these nuts...
10-32 lock nuts
Step 1 – Mount Vehicle RAM Mount Bracket
1. Determine the position for mounting the RAM ball base. Be sure to position the RAM assembly to allow access to
the ports on the back of the vehicle dock.
2. Attach the RAM ball base to the vehicle mounting surface using four 1/4 bolts (or equivalent) fasteners.
Note: 1/4 bolts not included.
IMPORTANT: Mount to the most rigid surface available.
11 - 12
Torque to
17 - 20 in/lb (0-95 - 1.10 N/m)