Protocol Tunneling Messages
Protocol Tunneling Messages
This section contains the protocol tunneling message.
Error Message PT-3-PT_HW_UNAVAIL: Protocol Tunneling hardware resource not
available. [chars]
Note
QOSMGR Messages
This section contains the quality of service (QoS) manager messages. An incorrect QoS setting causes
these messages.
Error Message QOSMGR-3-FEATURE_NOT_FOUND: Cannot find feature for [chars].
Error Message QOSMGR-3-FILTERTYPE_INVALID: Internal Error Invalid Policy filtertype
[dec].
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-72
This message applies only to the Catalyst Switch Module 3110.
Protocol tunneling could not be enabled because no redirect registers are available.
Explanation
Protocol tunneling requires redirect registers. [chars] is the hardware resource that is not available.
Recommended Action
Disable any applications that use redirect registers, and try configuring the
protocol tunneling again.
An internal software error has occurred. [chars] is the description of the feature that the
Explanation
software cannot find.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
Explanation
An internal software error has occurred. [dec] is the invalid filter type identification.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
1-6.
1-6.
Chapter 2
Message and Recovery Procedures
"Error Message Traceback
"Error Message Traceback
OL-12191-01