Dtp Messages - Cisco 3110 Message Manual

DTP Messages

Error Message DOT1X_SWITCH-5-ERR_VLAN_PROMISC_PORT: Attempt to assign VLAN [dec] to
promiscuous 802.1x port [chars]
Error Message DOT1X_SWITCH-5-ERR_VLAN_RESERVED: Attempt to assign reserved VLAN
[dec] to 802.1x port [chars]
Error Message DOT1X_SWITCH-5-ERR_VLAN_ROUTED_PORT: Attempt to assign VLAN [dec] to
routed 802.1x port [chars]
Error Message DOT1X_SWITCH-5-ERR_VLAN_RSPAN: Attempt to assign RSPAN VLAN [dec] to
802.1x port [chars]. 802.1x is incompatible with RSPAN
DTP Messages
This section contains the Dynamic Trunking Protocol (DTP) messages.
Error Message DTP-4-MEM_UNAVAIL: Memory was not available to perform the trunk
negotiation action.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-24
An attempt was made to assign a VLAN to a promiscuous IEEE 802.1x port, which is
Explanation
not allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action Change the mode of the port so that it is no longer a promiscuous port, or
change the configuration so that no VLAN is assigned.
An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
Explanation
specified is a reserved VLAN and cannot be assigned to this port. [dec] is the VLAN, and [chars] is
the port.
Update the configuration to not use this VLAN.
Recommended Action
An attempt was made to assign a VLAN to a routed IEEE 802.1x port, which is not
Explanation
allowed. [dec] is the VLAN, and [chars] is the port.
Change the mode of the port so that it is no longer a routed port, or change the
Recommended Action
configuration so that no VLAN is assigned.
Explanation An attempt was made to assign a remote SPAN VLAN to an IEEE 802.1x port. Remote
SPAN should not be enabled on a VLAN in which ports are configured with IEEE 802.1x enabled.
[dec] is the VLAN, and [chars] is the port.
Either disable remote SPAN configuration on the VLAN, or disable
Recommended Action
IEEE 802.1x on all the ports in this VLAN.
The system cannot negotiate trunks because of a lack of memory.
Explanation
Reduce other system activity to ease memory demands.
Recommended Action
Chapter 2 Message and Recovery Procedures
OL-12191-01