Cisco 3110 Message Manual page 45

Chapter 2 Message and Recovery Procedures
Error Message EC-5-L3DONTBNDL2: [chars] suspended: LACP currently not enabled on the
remote port.
Explanation
mode, the port is put in a suspended state. [chars] is the interface name.
Recommended Action
Error Message EC-5-L3DONTBNDL3: [chars] suspended: LACP not enabled on the remote
port.
Explanation
enabled. In this mode, the local port is put in a suspended state.
Recommended Action
Error Message EC-5-NOLACP: Invalid EC mode, LACP not enabled.
Explanation
image.
Recommended Action
Error Message EC-5-NOPAGP: Invalid EC mode, PAgP not enabled.
Explanation
to desirable or auto.
Recommended Action
channel-group channel-group-number mode on interface configuration command.
Error Message EC-5-PORTDOWN: Shutting down [chars] as its port-channel is
admin-down.
Explanation
aggregate port. If the administrative state of the aggregate port is down, the administrative state of
the port is also forced to be down. [chars] is the physical interface.
Recommended Action
to activate the aggregation port.
OL-12191-01
LACP is enabled on a Layer 3 interface but is not enabled on the partner port. In this
Enable LACP on the remote side.
LACP is enabled on a Layer 3 interface, but the remote port does not have LACP
Enable LACP on the remote port.
The EtherChannel mode cannot be set because LACP is not included in the software
Install a software image that includes LACP, and set the EC mode to on.
PAgP is not included in the Cisco IOS image and the EtherChannel mode cannot be set
Obtain an image with PAgP included, or set the mode to on by using the
The administrative state of the port is controlled by the administrative state of its
Enter the no shutdown interface configuration command on the aggregate port
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
EC Messages
2-29