Dot1X_Switch Messages - Cisco 3110 Message Manual

Chapter 2 Message and Recovery Procedures
Error Message DOT1X-5-INVALID_INPUT: Dot1x Interface parameter is Invalid on
interface [chars].
Error Message DOT1X-5-INVALID_MAC: Invalid MAC address(drop, zero, broadcast or
multicast mac address) [enet] is trying to authenticate.

DOT1X_SWITCH Messages

This section contains the IEEE 802.1x messages for switches.
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary
VLAN [dec] to 802.1x port [chars]
Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid
secondary VLAN [dec] to PVLAN host 802.1x port [chars]
OL-12191-01
The IEEE 802.1x interface parameter is out of the specified range or is invalid. [chars]
Explanation
is the interface.
Recommended Action Refer to the CLI help documentation to determine the valid IEEE 802.1x
parameters.
Authentication using IEEE 802.1x is not allowed for zero, broadcast, and multicast
Explanation
source MAC addresses. [enet] is the invalid MAC address.
Connect an IEEE 802.1x supported host to the IEEE 802.1x enabled port.
Recommended Action
The client MAC address could not be added to the MAC address table because the
Explanation
hardware memory is full, or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
If the hardware memory is full, remove some of the dynamic MAC addresses.
Recommended Action
If the client address is on another port, manually remove it from that port.
An attempt was made to assign a primary VLAN to an IEEE 802.1x port, which is not
Explanation
allowed. [dec] is the VLAN, and [chars] is the port.
Update the configuration to use a different VLAN.
Recommended Action
An attempt was made to assign a nonsecondary VLAN to a private VLAN host IEEE
Explanation
802.1x port. [dec] is the VLAN, and [chars] is the port.
Change the mode of the port so that it is no longer a private VLAN host port,
Recommended Action
or use a valid secondary VLAN.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
DOT1X_SWITCH Messages
2-21