Cisco 3110 Message Manual page 87

Chapter 2 Message and Recovery Procedures
Error Message PORT_SECURITY-2-PSECURE_VIOLATION_VLAN: Security violation on port
[chars] due to MAC address [enet] on VLAN [dec]
Explanation
secure port, MAC [enet] is the MAC address of the unauthorized device, and [dec] is the VLAN ID.
Recommended Action
Notify your network system administrator of this condition.
Error Message PORT_SECURITY-6-ADDR_REMOVED: Address [dec]:[enet] exists on port
[chars]. It has been removed from port [chars].
Explanation
configuration conflicts with the running configuration and has been deleted. [dec]:[enet] is the MAC
address of the port. [chars] is the reconfigured port.
Recommended Action
Error Message PORT_SECURITY-6-ADDRESSES_REMOVED: Maximum system secure address count
reached. Some secure addresses configured on port [chars] removed.
Explanation
the configuration. The number of secure addresses that the system supports was exceeded. This
condition occurs only during hot swapping or port-mode changes (for example, when the port is
converted from a Layer 3 to a Layer 2 port). [chars] is the port.
Recommended Action
Error Message PORT_SECURITY-6-VLAN_FULL: Vlan [dec] on port [chars] has reached its
limit. Address [enet] has been removed.
Explanation
addresses reached the maximum limit allowed on the access VLAN. The address is deleted. [dec] is
the VLAN ID, [chars] is the port assigned to the voice VLAN and the access VLAN, and [enet] is
the MAC address that is deleted.
Recommended Action
Error Message PORT_SECURITY-6-VLAN_REMOVED: VLAN [int] is no longer allowed on port
[chars]. Its port security configuration has been removed.
Explanation
VLAN list change and is removed from the configuration. [int] is the VLAN ID, and [chars] is the
switch port assigned to the VLAN.
Recommended Action
OL-12191-01
An unauthorized device attempted to connect on a secure trunk port. [chars] is the
Identify the device that attempted to connect through the secure trunk port.
A routed port is reconfigured as a switch port. The address in the previous switch
No action is required.
Some configured and sticky MAC addresses on the specified port were removed from
No action is required.
The voice VLAN is the same as the access VLAN, and the maximum number of MAC
No action is required.
A configured VLAN is not allowed either due to a port mode change or an allowed
No action is required.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
PORT_SECURITY Messages
2-71