Dwl Messages - Cisco 3110 Message Manual

DWL Messages

Error Message DTP-5-TRUNKPORTON: Port [chars] has become [chars] trunk.
DWL Messages
This section contains the down-when-looped (DWL) message. This feature disables an interface when a
loopback is detected.
Error Message DWL-3-LOOP_BACK_DETECTED: Loop-back detected on [chars].
EC Messages
This section contains the EtherChannel, Link Aggregation Control Protocol (LACP), and Port
Aggregation Protocol (PAgP) messages.
Error Message EC-4-NOMEM: Not enough memory available for [chars].
Error Message EC-5-BUNDLE: Interface [chars] joined port-channel [chars].
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-26
The interface has changed from an access port to a trunk port. The first [chars] is the
Explanation
interface, and the second [chars] is the encapsulation type.
This message is provided for information only.
Recommended Action
There is a loopback on the specified port that might be caused by a Token-Ring Type-1
Explanation
cable connected to the port or a misconfiguration in the network. [chars] is the port.
Correct the problem that is causing the loopback condition. Then enter the
Recommended Action
shutdown and the no shutdown interface configuration commands.
Explanation Either the LACP or the PAgP EtherChannel could not get the memory it needed to
initialize the required data structures. [chars] is the data structure name.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
The listed interface joined the specified EtherChannel. The first [chars] is the physical
Explanation
interface, and the second [chars] is the EtherChannel interface.
No action is required.
Recommended Action
1-6.
Chapter 2 Message and Recovery Procedures
"Error Message Traceback
OL-12191-01