Backup_Interface Messages - Cisco 3110 Message Manual

Chapter 2 Message and Recovery Procedures
Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature.

BACKUP_INTERFACE Messages

This section contains the Flex Link messages.
Error Message BACKUP_INTERFACE-5-PREEMPT: Preempting interface [chars] in backup
pair ([chars], [chars]), preemption mode is [chars]
Error Message BACKUP_INTERFACE-5-VLB_NON_TRUNK: Warning:
allowed on non-trunk ports.
BADTRANSCEIVER Messages
This section contains the BADTRANSCEIVER message.
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].
Note
OL-12191-01
The ACL manager was unable to fit the complete configuration into the hardware, so
Explanation
some features will be applied in software. This prevents some or all of the packets in a VLAN from
being forwarded in hardware and requires them to be forwarded by the CPU. Multicast packets
might be dropped entirely instead of being forwarded. [chars] is the direction (input or output), and
[dec] is the label number.
Use a simpler configuration. Use the same ACLs on multiple interfaces, if
Recommended Action
possible.
The switch is preempting the current forwarding interface in the backup interface pair.
Explanation
The first [chars] is the number of the current forwarding interface. The second and third [chars] are
the names of the interfaces in the backup pair, and the fourth [chars] is the pre-preemption mode.
No action is required.
Recommended Action
Flex Link VLB detects a nontrunk port. [chars] is the interface name.
Explanation
Recommended Action Configure the interface to operate in trunking mode.
This message applies only to the Catalyst Switch Module 3110.
A defective module is installed in the specified interface. [chars] is the interface.
Explanation
Remove the transceiver. If it was purchased from Cisco, contact your Cisco
Recommended Action
representative to have the transceiver replaced.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
Please configure [chars] to be a trunk port.
BACKUP_INTERFACE Messages
Flexlink VLB is not
2-7